XENO XDR Series Installation And User Manual - page 73
of
112
7-8. Network Setup
[1] DVR Network Setup
Check Network
1) Click Windows START button.
2) Click RUN and input “cmd”.
3) Input “ipconfig” from COMMAND AND PROMPT.
4) Check IP address, Subnet Mask and Gateway.
5) Type “Ping xxx.xxx.xxx.xxx (IP address)”.
If you see “Request timed out” message, network is not connected. IP address which failed Ping
Test can not be used.
6) If Ping test is successful, you will see message as in below image :
73