XENO XDR Series Installation And User Manual - page 89
8-3. Remote Viewer
[1] Remote Viewer
1
2
3
4
8
7
5
6
9
1) DVR connection setup: Input IP address, Port number, ID, Password for network connection to DVR.
2) System Information: Displays DVR connection and progress status.
3) Audio channel : Select an audio channel to turn on. Note that the ‘Enable Audio’ checkbox in 7) Setup
should be checked as enabled and both Refresh Rate and Quality should be set to ‘Low’, otherwise audio
quality may suffer.
4) Screen division : Select layout of split screen.
5) PTZ Control: Control PTZ cameras connected to DVR.
(PTZ setting in DVR should be completed before use )
(PTZ setting in DVR should be completed before use.)
6) Connect : Connect to DVR via network to view live image.
Disconnect : Disconnect network connection.
7) Setup : Set quality and frame rate for each camera channel.
8) 2-Way Audio : Enable 2-way audio system between DVR and Viewer.
Note that both Refresh Rate and Quality in 7) Setup should be set to ‘Low’ while operating 2-Way Audio,
otherwise audio quality may suffer.
9) Channel selection : Select a channel or a group of channels to display in full-screen or in 4/9/16 split
screen mode
screen mode.
89