Xerox 6100BD - Phaser Color Laser Printer User Manual - page 16
Other manuals for 6100BD - Phaser Color Laser Printer:
System Manual, Getting Started, Install Manual, Installation Manual, Specifications, User Manual, User Manual, Security Manual, Install Manual, Release Note, Install Manual, Operator's Manual, Color Management Manual, Fundamentals, Manual, System Manual, System Manual, Using Manual, User Manual, Getting Started, Manual, Manual, Getting Started, Manual, Installation Manual
Manual is about: Using LCDS Print Description Language
of
32
1 2
MICR User Guide
NOTE: 600 dpi PCL fonts must not be used with a 300 dpi queue
or with any 300 dpi resources. The resolution mismatch causes
characters to be one dot further apart than is nominal. While this
spacing meets industry standards, a high reject rate can result if
the adjacent field spacing does not compensate for this error.
You can use the PCL Unit of Measure command to set the PCL
Unit to 600 (for example,
override the resolution to 600 dpi in the queue. Refer to “Setting
the font resolution,” later in this chapter, for information on setting
the resolution in the queue.