Xerox Phaser 2135 Advanced Features And Troubleshooting Manual - page 105
92
Phaser 2135 Color Printer
Troubleshooting
Un-LED Error
[U18-Yellow LED Bar Missing]
[U19-Magenta LED Bar Missing]
[U20-Cyan LED Bar Missing]
[U21-Black LED Bar Missing]
Fault
The LED bar is not recognized by the printer. Turn
off the printer, wait 15 seconds, then turn on the
printer. If the problem persists, check the support
links at:
www.xerox.com/officeprinting/infoSMART.
Un-Toner Missing
[U22-Yellow Toner Missing]
[U23-Magenta Toner Missing]
[U24-Cyan Toner Missing]
[U25-Black Toner Missing]
Reseat Toner
Fault
The toner is either missing or must be reseated to
be recognized by the printer. Turn off the printer,
wait 15 seconds, then turn on the printer. If the
problem persists, check the support links at:
www.xerox.com/officeprinting/infoSMART.
Un-Drum Error
[U26-Yellow Drum Error]
[U27-Magenta Drum Error]
[U28-Cyan Drum Error]
[U29-Black Drum Error]
Fault
The imaging drum is either missing or must be
reseated to be recognized by the printer. Turn off
the printer, make sure the imaging drum is
properly installed, and turn on the printer. If the
problem persists, install a new imaging drum. For
further assistance, visit the support links at:
www.xerox.com/officeprinting/infoSMART.
Wn-Toner Low
[W1-Yellow Toner Low]
[W2-Magenta Toner Low]
[W3-Cyan Toner Low]
[W4-Black Toner Low]
Attention
The toner is low and should be replaced soon.
Printing can continue until the printer determines
that the toner is at its end of life; however, some
degradation of image quality may occur. The
message will remain until interrupted by other
messages or until the toner is replaced
W5-Transfer Belt Near End Of
Life
Attention
The transfer belt is near its end of life. Printing can
continue until the printer determines that the
transfer belt is at its end of life; however, some
degradation of image quality may occur. The
message will remain until interrupted by other
messages or until the transfer belt is replaced.
W6-Fuser Near End Of Life
Attention
The fuser is near its end of life. Printing can
continue until the printer determines that the
fuser is at its end of life, however some
degradation of image quality may occur. The
message will remain until interrupted by other
messages or until the fuser is replaced.
Wn-Drum
[W7-Yellow Drum]
[W8-Magenta Drum]
[W9-Cyan Drum]
[W10-Black Drum]
Near End Of Life
Attention
The imaging drum is near its end of life. Printing
can continue until the printer determines that the
imaging drum is at its end of life, however some
degradation of image quality may occur. The
message will remain until interrupted by other
messages or until the imaging drum is replaced.
W11-Tray 1 Paper Low
Attention
The printer has detected that the paper level in
Tray 1 is low. Printing can continue until the tray
runs out of paper. Reload the tray as soon as
possible to avoid printing interruptions.
W12-Tray 2 Paper Low
Attention
The printer has detected that the paper level in
Tray 2 is low. Printing can continue until the tray
runs out of paper. Reload the tray as soon as
possible to avoid printing interruptions.
Printer Management Status Messages (cont'd.)