Xerox Phaser 2135 Advanced Features And Troubleshooting Manual - page 93
80
Phaser 2135 Color Printer
Troubleshooting
Engine EPROM Missing U3
Power Off/On
Fault
During the printer’s self-diagnostics there was a
problem detecting the engine EPROM. Turn off the
printer, wait 15 seconds, then turn on the printer. If
the problem persists, check the support links at:
www.xerox.com/officeprinting/infoSMART.
Engine RAM Error U1
Power Off/On
Fault
During the printer’s self-diagnostics there was a
problem reading the engine RAM. Turn off the
printer, wait 15 seconds, then turn on the printer. If
the problem persists, check the support links at:
www.xerox.com/officeprinting/infoSMART.
Engine ROM Error U0
Power Off/On
Fault
During the printer’s self-diagnostics there was a
problem reading the engine ROM. Turn off the
printer, wait 15 seconds, then turn on the printer. If
the problem persists, check the support links at:
www.xerox.com/officeprinting/infoSMART.
Engine SRAM Error U4
Power Off/On
Fault
During the printer’s self-diagnostics there was a
problem reading the engine SRAM. Turn off the
printer, wait 15 seconds, then turn on the printer. If
the problem persists, check the support links at:
www.xerox.com/officeprinting/infoSMART.
Feeder Home Error U7
Power Off/On
Fault
An error has been detected with the home position
of the front paper feeder. Turn off the printer, wait
15 seconds, then turn on the printer. If the problem
persists, check the support links at:
www.xerox.com/officeprinting/infoSMART.
Fuser Lower Error T2
Power Off/On
Fault
An error in the lower fuser Thermistor was
discovered. Turn off the printer, wait 15 seconds,
then turn on the printer. If the problem persists,
install a new fuser. For further assistance, visit the
support links at:
www.xerox.com/officeprinting/infoSMART.
Fuser Missing
Reseat Fuser
Fault
The fuser is either missing or must be reseated to be
recognized by the printer. Turn off the printer, make
sure the fuser is properly installed, and turn on the
printer. If the problem persists, install a new fuser.
For further assistance, visit the support links at:
www.xerox.com/officeprinting/infoSMART.
Front Panel Messages (cont'd.)