Xerox Phaser 2135 Advanced Features And Troubleshooting Manual - page 97
84
Phaser 2135 Color Printer
Troubleshooting
Supply Fan Error U9
Power Off/On
Fault
An error has been detected with the power supply
cooling fan. Turn off the printer, wait 15 seconds,
then turn on the printer. If the problem persists,
check the support links at:
www.xerox.com/officeprinting/infoSMART.
Temp Sensor Error T29
Power Off/On
Fault
The temperature sensor is either not communicating
or reporting invalid data. Turn off the printer, wait
15 seconds, then turn on the printer. If the problem
persists, check the support links at:
www.xerox.com/officeprinting/infoSMART.
Toner Empty
[Black Toner Empty]
[Cyan Toner Empty]
[Magenta Toner Empty]
[Yellow Toner Empty]
Replace Toner
Fault
The toner cartridge has reached its end of life.
Install a new toner cartridge.
Toner Low
[Black Toner Low]
[Cyan Toner Low]
[Magenta Toner Low]
[Yellow Toner Low]
Attention The level of toner in the toner cartridge is low, and
should be replaced soon, as it is near its end of life.
Printing can continue until the toner cartridge is
empty; however, some degradation of image quality
may occur. The message will remain until
interrupted by other messages or until the toner
cartridge is replaced.
Top Cover Open
Close Top Cover
Fault
The Top Cover is open. Close the cover so that
printing can continue.
Top Output Tray Full
Remove Outputs
Fault
The top (face down) tray is full, and cannot accept
any more prints until it is emptied. Once emptied,
printing will continue where it left off.
Transfer Belt Missing
Reseat Belt
Fault
The transfer belt is either missing or must be
reseated to be recognized by the printer. Turn off the
printer, make sure the transfer belt is properly
installed, and turn on the printer. If the problem
persists, install a new transfer belt. For further
assistance, visit the support links at:
www.xerox.com/officeprinting/infoSMART.
Front Panel Messages (cont'd.)