Xerox Phaser 2135 Advanced Features And Troubleshooting Manual - page 8
User safety summary
Your printer and the recommended consumable supplies have been designed and tested to meet strict safety
requirements. Attention to the following notes will ensure the continued safe operation of your printer.
Electrical Safety
■
Use the power cord supplied with your printer.
■
Do not use a ground adapter plug to connect the printer to a power source receptacle that lacks a ground
connection terminal.
■
Plug the power cord directly into a properly grounded electrical outlet. Do not use an extension cord. If you
do not know whether an outlet is grounded, ask an electrician to check the outlet.
Warning
Avoid the potential of severe electrical shock by ensuring the printer is properly grounded.
■
Do not place the printer where people may step on the power cord.
■
Do not place objects on the power cord.
■
Do not obstruct the ventilation openings. These openings are provided to prevent overheating of the
printer.
Warning
Do not push objects into slots and openings on the printer. Making a contact
with a voltage point or
shorting out a part could result in fire or electrical shock.
■
If you notice unusual noises or odors, switch off the printer power immediately. Disconnect the power cord
from the electrical outlet. Call an authorized service representative to correct the problem.
■
The power cord is attached to the printer as a plug-in device at the back of the printer. In the event it is
necessary to remove all electrical power from the printer, disconnect the power cord from the power
receptacle.
■
If any of the following conditions occur, switch off the printer power immediately, disconnect the power
cord, and call an authorized service representative.
■
The power cord is damaged or frayed.
■
Liquid is spilled into the printer.
■
The printer is exposed to water.
■
Any part of the printer is damaged.
Maintenance Safety
■
Do not attempt any maintenance procedure that is not specifically described in the documentation
supplied with your printer.
■
Do not use aerosol cleaners. The use of supplies that are not approved may cause poor performance and
could create a dangerous condition.
■
Do not remove the covers or guards that are fastened with screws unless you are installing optional
equipment and are specifically instructed to do so. Power should be OFF when performing these
installations. Except for user installable options, there are no parts that you can maintain or service behind
these covers.
Operational Safety
Your printer and supplies were designed and tested to meet strict safety requirements. These include safety
agency examination, approval, and compliance with established environmental standards.
Your attention to the following safety guidelines will help to ensure the continued safe operation of your printer.
■
Use the material and supplies specifically designed for your printer. The use of unsuitable materials may
result in poor performance and possibly a hazardous situation.
■
Follow all warnings and instructions marked on, or supplied with, the printer, options and supplies.