Yamaha LS9 Editor Quick Start Manual - Scene Data
11
Settings that are Recalled with Scenes
Scene Data
When a scene is saved the parameters listed under “Settings that are Recalled with Scenes,” above, are saved in the
specified scene memory.
All parameters listed under “Settings that are Not Recalled with Scenes” above, not including the knob settings, are saved in
the console’s global memory Those settings are not recalled with scenes, but are retained in memory when the console is
turned off and restored when the console is turned on
You can specify that certain parameters are not to be recalled when a scene is recalled This is the “Recall Safe” function, and
it can be accessed by pressing the CHANNEL JOB key in the DISPLAY ACCESS section as many times as necessary until
the RECALL SAFE display appears
The LS9 actually provides 01 scenes: the read-only
scene 000, 99 user scenes, and the current scene.
• Channel name and icon.
• Fader position.
• Routing (input, output, insert in/out, direct out, monitor output,
cascade, virtual rack).
• Insert settings (on/off, position).
• Direct out settings (on/off, position, level).
• EQ settings (all parameters, including HPF).
• ATT (digital attenuator).
• Dynamics 1 and settings (all parameters).
• Rack settings (all parameters).
• MIX send settings (pass, on/off, level, pre/post).
• MATRIX send settings (pass, on/off, level, pre/post).
• Pan/balance settings (stereo/mono/LCR).
• MUTE group settings (assignments, on/off).
• Channel link settings.
• Fade function (on, fade time).
• Focus function.
• Routing between rear-panel input and TALKBACK
(TALKBACK IN level setting in the MONITOR display page).
Settings that are Not Recalled with Scenes
• User defined keys.
• Preference settings.
• MONITOR LEVEL knob setting.
• PHONES LEVEL knob setting.
• TALKBACK LEVEL knob setting.
• Touch screen/LED/lamp brightness settings.
• OUTPUT PORT settings (excluding routing).
• MIDI settings.
• Word clock settings.
• Phantom master power settings.
• CUE pop-up window settings
(PFL input trim, DCA trim, PFL output trim).
• MONITOR pop-up window settings
(level, monitor source, monaural monitor, link).
• Oscillator settings (all parameters).
• Mute safe/recall safe function settings.
• Password.
• Screen page or pop-up window.
• SENDS ON FADERS mode settings (on/off, assigned channel).
• Meter point settings.
• Head amp slot input assignments.