Yamaha LS9 Editor Quick Start Manual - Selected Channel Section

The Selected Channel section on an LS9 console corresponds to the channels modules on a traditional analog console, 

providing access to all of the main parameters for the currently selected channel  The channel to be controlled is selected by 

pressing it’s [SEL] key  Head amp gain, EQ, dynamics, pan/balance, mix and matrix bus send level, and other parameters can 

be controlled via the encoders and keys on the panel

Analog Mixer Channel 

Module

LS9 Selected Channel 

Section

LS9 Channel 

Module Section

Note:The analog channel module shown is from the MG4/14 mixer, but since it does not have the same number of AUX and EFF controls as the LS9 it should be referred to only as an example.

The Selected Channel section is located 

to the right of the LCD panel.

● Module Comparison

The channel module controls the parameters shown 

in this section of the display. This corresponds to 

the lower section of the analog console channel 

module, shown to the left.

The Selected Channel section encoders and keys control the parameters that 

appear in this section of the display. This includes head amp gain, EQ, two 

different dynamics thresholds, panning/balance, and other controls 

corresponding to those in the upper section of the analog console channel 

module shown to the left. The HPF can be controlled via the display only.

The parameters 

for the channel 

selected via the 

[SEL] keys appear 

on the display

Selected Channel Section

4