Yamaha LS9 Editor Quick Start Manual - Check Your Connections

When working with an analog console it was always 

necessary to check that all controls were “normalized” 

before setting up a mix  This meant spending a 

considerable amount of time to make sure that more than 

1,000 controls (on most large consoles) were set to the 

appropriate neutral positions: gain controls to minimum, 

EQ controls to their flat settings, etc.

On the LS9 all channel controls are concentrated in the 

Selected Channel section, and all default settings are 

stored in scene number 000  So all you have to do to 

normalize or “reset” the entire console is to recall scene 

000

Check Your Connections

This document presumes that you have already made the necessary connections and have set up the console for basic 

sound output as described in the Quick Start Guide  Check your setup one more time before trying out the functions 

described in this document

Console Preparation

Analog input connectors (monaural).

Power cable socket.

POWER switch.

Scene 000

Are the main left and right outputs appearing properly at OMNI OUT connectors 15 (7) and 16 (8)?