Yamaha LS9 Editor Quick Start Manual - Sends On Fader Mode
5
In the Sends On Fader mode you can use the console’s faders to adjust send levels to the MIX buses, or send levels from the
MIX, STEREO (L/R), and MONO buses to the MATRIX buses, and use the ON keys to turn those sends on or off
The LS9 also allows these adjustments to be made from the main display using the cursor keys and data dial, but by
switching to the physical faders for these operations you have more hands-on, intuitive control
● Sends from the Channels to the MIX Buses
1) With a channel layer selected ([1-16] or [17-32] on the LS9-16;
[1-32] or [33-64] on the LS9-32), make sure than only one of the
MIX/MATRIX select buttons to the left of the display is selected and
lit
2) Use the MIX/MATRIX select buttons to select the MIX bus you
want to edit (press the button once) The selected MIX bus button
will light
3) Press the same button a second time and all buttons in the
MIX/MATRIX section while light, while the selected button flashes.
“SENDS ON FADER” will flash at the top of the display.
Indicates that the SENDS ON FADER mode is active.
This will flash on the actual display.
Displays the currently selected MIX bus.
The bus knobs that were showing in the main display will disappear,
indicating that control has been transferred to the console’s faders.
Same send levels.
In the SENDS ON FADER mode you can directly
control the send levels without having to open
the SEND TO MIX display.
These settings can also be made via the SEND TO
MIX display that appears when you press the
SEND button in the main display.
Signals can be sent to the MATRIX buses from the MIX, STEREO (L/R) and MONO buses in the same way
(the display will be different)