3D Systems CUBE User manual - page 22

18

3D Systems, Inc

.

18 .  Mount the cartridge on the right side of the printer and select the 

checkmark

 to 

continue .

NOTE: It may become necessary to slightly rotate the cartridge to 

seat it properly .

NOTE: The print jet will begin to heat . Once the print jet has reached 

the proper temperature, the printer will prime melted material into 

the refuse bin .

19 .  The right cartridge has been installed . Select the 

checkmark

 to continue .

20 .  Select 

PRINT

 .

21 .  It is recommended that Auto Level is performed prior to the first print. Ensure 

the print pad is clean and installed properly and then select the 

checkmark

 to 

continue to Auto Level .

NOTE: When installed properly, the print pad magnetically 

attaches to the adjustment knobs .