3D Systems CUBE User manual - page 95

91

3D Systems, Inc

.

NOTE: The firmware will begin to install. The blue bar is a progress 

indicator .

NOTE: The installation could take a few minutes .

WARNING: DO NOT POWER OFF OR DISCONNECT THE PRINTER 

FROM UTILITY POWER DURING THE UPDATE PROCESS .

NOTE: If the firmware update fails. Select 

RETRY

 to attempt to install 

the firmware again. Select 

CANCEL

 to stop the firmware update.

4 .  When prompted, press and release the 

power button

 and wait until the display 

turns on . 

NOTE: It may take a minute for the display to turn on .

5 .  Perform the Auto Level and Auto Gap procedures .

NOTE: For more information, refer to the section titled 

Print Pad 

Calibration

 .