3D Systems CUBE User manual - page 91
Other manuals for CUBE:
User Manual, Quick Start Manual, Quick Start Manual, User Manual, User Manual
Manual is about: Personal 3D Printer 3rd Generation
of
102
87
3D Systems, Inc
.
TEST PRINT
Test print allows you to print the same welcome message that is printed during the initial setup of the printer . The print is very useful for
determining if the gap between the left print jet and the print pad is correct .
1 . Select
TEST PRINT
.
2 . Select
.
NOTE: If the color built into the test print does not match a
color of one of the installed cartridges, the printer will assign an
installed cartridge color to the test print .
3 . Apply two thin layers of Cube Glue to the print pad . Select the checkmark to
continue .
NOTE: Apply enough glue to cover a square area of 5” (15 cm) .
NOTE: For best results, allow the glue to dry before printing .