3D Systems CUBE User manual - page 32
28
3D Systems, Inc
.
NOTE: If the print file requires PLA material and ABS material is
installed, the printer will prompt you to change the cartridge(s) .
Select
CHANGE CARTRIDGE
and refer to the section titled
Replacing A Material Cartridge
for instructions on replacing
cartridge .
NOTE: If the print file requires ABS material and PLA material is
installed, the printer will prompt you to change the cartridge(s) .
Select
CHANGE CARTRIDGE
and refer to the section titled
Replacing
A Material Cartridge
for instructions on replacing cartridge .
NOTE: If there is not enough material in the cartridge to complete
the print, the printer will prompt you to either change the cartridge(s)
or continue using the cartridge until the print material has been
depleted . To change the cartridge, select
CHANGE CARTRIDGE
and refer to the section titled
Replacing A Material Cartridge
for
instructions on replacing cartridge . Select
SKIP
to continue using
the remaining material in the cartridge . You will be prompted to
replace the cartridge once the material has been depleted .
NOTE: If there is not enough material to complete the print but you
want to use up the remaining material, select the
checkmark
to
continue printing .
NOTE: If the file was built with color(s) that are not installed, the
printer will assign a color from one of the installed cartridges that
match the material type . Select the
checkmark
to continue .