Banner Q4X Quick start manual - page 3
Installation
Install the Safety Label
The safety label must be installed on Q4X sensors that are used in the
United States.
Note: Position the label on the cable in a location that
has minimal chemical exposure.
1. Remove the protective cover from the adhesive on the label.
2. Wrap the label around the Q4X cable, as shown.
3. Press the two halves of the label together.
COMPLIES WITH IEC 60825-1:2007
CLASS 1
LASER PRODUCT
COMPLIES WITH 21 CFR 1040.10 AND 1040.11
EXCEPT FOR DEVIATIONS PURSUANT TO
LASER NOTICE No. 50, DATED JUNE 24, 2007.
BANNER ENGINEERING CORP.
9714 10TH AVENUE NORTH
MINNEAPOLIS, MN 55441
COMPLIES WITH
IEC 60825-1:2007
CLASS
1
LASER PRODUCT
Figure 4. Safety Label Installation
Sensor Orientation
Optimize detection reliability and minimum object separation performance with correct sensor-to-target orientation. To
ensure reliable detection, orient the sensor as shown in relation to the target to be detected.
Figure 5. Optimal Orientation of Target to Sensor
See the following figures for examples of correct and incorrect sensor-to-target orientation as certain placements may
pose problems for sensing some targets. The Q4X can be used in the less preferred orientation and provide reliable
detection performance; refer to the Performance Curves for the minimum object separation distance required for each
case.
Incorrect
Correct
Figure 6. Orientation by a wall
Incorrect
Correct
Figure 7. Orientation for a turning object
Incorrect
Correct
Figure 8. Orientation for a height difference
Horizontal
Orientation
Vertical
Orientation
(Optimal)
Figure 9. Orientation for a color or luster difference
Mount the Sensor
1. If a bracket is needed, mount the sensor onto the bracket.
2. Mount the sensor (or the sensor and the bracket) to the machine or equipment at the desired location. Do not tighten
the mounting screws at this time.
3. Check the sensor alignment.
4. Tighten the mounting screws to secure the sensor (or the sensor and the bracket) in the aligned position.
Q4X Stainless Steel Laser Sensor with Dual Discrete Outputs and IO-Link
P/N 190073 Rev. E
www.bannerengineering.com - Tel: +1-763-544-3164
3