Banner Q4X Quick start manual - page 4
Wiring Diagram
4
1
3
2
10-30V dc
CH1
CH2
+
–
PUSH-PULL
Load
Load
Figure 10. Channel 2 as PNP discrete or PFM output
4
1
3
2
10-30V dc
CH1
CH2
+
–
PUSH-PULL
Load
Remote
Input
Figure 11. Channel 2 as remote input
1
4
3
2
Key
1 = Brown
2 = White
3 = Blue
4 = Black
Note: Open lead wires must be connected to a terminal block.
Note: The Channel 2 wire function is user-selectable. The default for the wire is PNP output. See the
Instruction Manual for details regarding use as remote input or PFM output.
Cleaning and Maintenance
Handle the sensor with care during installation and operation. Sensor windows soiled by fingerprints, dust, water, oil, etc.
may create stray light that may degrade the peak performance of the sensor. Blow the window clear using filtered,
compressed air, then clean as necessary using water and a lint-free cloth.
Sensor Programming
Program the sensor using the buttons on the sensor or the remote input (limited programming options).
In addition to programming the sensor, use the remote input to disable the buttons for security, preventing unauthorized
or accidental programming changes. See the Instruction Manual, p/n 190074 for more information.
Setup Mode
Access Setup mode and the sensor menu from Run mode by pressing and holding MODE for longer than 2 seconds. Use
and
to navigate through the menu. Press SELECT to select a menu option and access the submenus. Use
and
to navigate through the submenus. Press SELECT to select a submenu option and return to the top menu, or press
and hold SELECT for longer than 2 seconds to select a submenu option and return immediately to Run mode.
To exit Setup mode and return to Run mode, navigate to
and press SELECT.
Note: The number that follows a menu option, for example
, indicates the channel that is
selected. For menu items without a number (excluding submenu items), these menu options are only
available from Channel 1 and the settings apply to both channels.
Q4X Stainless Steel Laser Sensor with Dual Discrete Outputs and IO-Link
4
www.bannerengineering.com - Tel: +1-763-544-3164
P/N 190073 Rev. E