D-Link DES-3326 User Manual - Switch Operation Mode
24-port NWay Ethernet Switch User’s Guide
152
Configuring the Switch Using the Console Interface
The options are 2 mins, 5 mins, 10 mins, 15 mins,
or Never.
??
Baud Rate
- Sets the serial bit rate that will be used
to communicate the next time the Switch is restarted.
Applies only when the serial port is being used for out-
of-band (SLIP) management; it does not apply when
the port is used for the console port. Available speeds
are 2400, 9600, 19,200 and 38,400 bits per second.
The default setting is 9600.
??
Interface Name –
This allows for the naming of the
SLIP interface for easy reference.
??
Remote IP Address –
This is the IP address of the
management station that will use the SLIP protocol to
communicate with the switch.
Switch Operation Mode
Note: The switch will retain the configuration entered
for IP Routing when in Layer 2 Only mode (if the
configuration is saved to NV-RAM), but the IP Routing
configuration will not be active. The IP Routing
configuration will become active when the switch is again
put in IP Routing mode.
Note: Putting the switch in IP Routing mode does not –
by itself – enable IP routing. The switch must be
configured to use IP interfaces before it is capable of IP
routing. (See the section titled Setting up IP Interfaces
below.)
The switch can operate in one of two modes: