D-Link DES-3326 User Manual - 10Base-T Device
24-port NWay Ethernet Switch User’s Guide
28
Connecting The Switch
? ?
A 10BASE-T hub or switch can be connected to the Switch
via a two-pair Category 3, 4 or 5 UTP/STP straight cable.
? ?
A 100BASE-TX hub or switch can be connected to the
Switch via a two-pair Category 5e UTP/STP straight cable.
If the other switch or hub contains an unused Uplink port, we
suggest connecting the other device’s Uplink (MDI-II) port to any
of the switch’s (MDI-X) ports (1x - 22x, or one of the optional
Gigabit module ports) using a normal straight-through cable, as
shown below.
If the other device does not have an unused Uplink port, make
the connection with a normal straight-through cable from the
Uplink port on the switch to any normal crossed port on the hub.
Alternatively, if you have a crossover cable you can save the
Uplink ports for other connections and make this one from a
crossed port to another crossed port.
Figure 4-2. Switch connected to a normal (non-Uplink) port on a
hub or switch using a straight or crossover cable
10BASE-T Device
For a 10BASE-T device, the Switch’s LED indicators should
display the following: