D-Link DES-3326 User Manual - Dvmrp
24-port NWay Ethernet Switch User’s Guide
192
Configuring the Switch Using the Console Interface
Figure 6-46. IGMP Interface Configuration
Enter the name of the interface in the Interface-
Name:[ ]
field. This interface must be previously
defined.
The Ver:< > field can be toggled between 1 and 2. This is the
version of IGMP that the interface will use (IGMP version 1 or
version 2).
The Query:[ ] field allows an entry between 1 and 65535
seconds and defines the time between transmitting IGMP queries.
The Max-Response:[ ] field allows an entry between 1 and 254
and defines the maximum time allowed before sending a
response report to a query measured in units of 1/10 of a second.
This is used to adjust the “leave latency”, the time internal
between the moment the last host leaves a group and when the
routing protocol is notified there are no more members.
The Robustness Var.[ ] field allows an entry between 1 and
255 that defines the maximum time (in seconds) between the
receipt of IGMP queries. If this timer expires without the
receipt of another IGMP query, the switch addumes the querier
is no longer present.
DVMRP
To configure DVMRP for an IP interface:
Highlight DVMPR Interface Configuration from the Setup
IP Multicast
menu and press enter.