D-Link DES-3326 User Manual - Power Failure
Manual is about: 24-Port Fast Ethernet Plus 2-Port Gigabit Module Layer 3 Switch
of
425
24-port NWay Ethernet Switch User’s Guide
18
Unpacking and Setup
? ?
All LED indicators will momentarily blink. This blinking of
the LED indicators represents a reset of the system.
? ?
The power LED indicator will blink while the Switch loads
onboard software and performs a self-test. After
approximately 20 seconds, the LED will light again to
indicate the switch is in a ready state.
? ?
The console LED indicator will remain ON if there is a
connection at the RS-232 port, otherwise this LED
indicator is OFF.
? ?
The 100M LED indicator may remain ON or OFF
depending on the transmission speed.
Power Failure
As a precaution in the event of a power failure, unplug the switch.
When power is resumed, plug the switch back in.