D-Link DES-3326SR Manual - Chapter 19
D-Link DES-3326SR Layer 3 Switch
Chapter 19
Configure VLANs
Configure 802.1Q Static VLANs
802.1Q Port Settings
Switch GVRP
This chapter describes how to use the web manager to configure VLANs in the Switch. If you are not familiar
with using VLANs on a Layer 3 Switch, it would be a good idea to read the previous section. All the menus
needed to create and configure VLANs are located in their own subdirectory in the Advanced Setup folder.
NOTE: The Switch allows the assignment of an IP interface to each VLAN, in IP
Routing mode. The VLANs must be configured prior to setting up the IP interfaces.
Configure 802.1Q Static VLANs
The VLAN menu adds an entry to edit the VLAN definitions and to configure the port settings for IEEE 802.1Q
VLAN support. Go to the Advanced Setup folder, open the VLAN Configurations subdirectory, and click the
802.1Q VLANs link to open the following dialog box:
Figure 19- 1. 802.1Q VLANs
To delete an existing 802.1Q VLAN, click the corresponding click-box to the left of the VLAN you want to
delete from the switch and then click the Delete button.
To create a new 802.1Q VLAN, click the New button and configure membership for the VLAN in the 802.1Q
VLANs Add menu.
136