D-Link DES-3326SR Manual - page 163
D-Link DES-3326SR Layer 3 Switch
The following fields can be set:
Parameter
Description
IP Address <0.0.0.0>
Allows the entry of an IP address that will be a static entry into the
Switch’s Routing Table.
Subnet Mask <0.0.0.0>
Allows the entry of a subnet mask corresponding to the IP address
above.
Gateway IP <0.0.0.0>
Allows the entry of an IP address of a gateway for the IP address
above.
Metric <1 >
Allows the entry of a routing protocol metric representing the
number of routers between the Switch and the IP address above.
Backup Status
Specify the route as Primary or Backup. If a single IP route is used,
it is unnecessary to change this. Designate a backup route if an
alternate route is desired. A backup IP route is sometimes called
‘”floating static route”.
Configure Static ARP
To make a static ARP entry, click the IP Forwarding folder and then the Static ARP link:
Figure 22- 3. Static ARP
To delete an existing static ARP entry, click corresponding click-box and then click the Delete button.
To add a new static ARP entry, click the New button:
Figure 22- 4. Static ARP – Add
The following fields can be set:
Parameter
Description
IP Address
The IP address of the ARP entry.
MAC Address
The MAC address of the ARP entry.
153