D-Link DES-3326SR Manual - Switch Ip Settings
D-Link DES-3326SR Layer 3 Switch
Switch IP Settings
Switch IP settings may initially be set using the
console interface prior to connecting to it
through the Ethernet. If the Switch IP address
has not yet been changed, read the Introduction
of the CLI Reference or read the instructions
below on how to use the console port and CLI IP
settings commands to establish IP settings for the
Switch.
To change IP settings using the web manager
you must access the Basic Switch Setup menu
the Switch. Follow the
Location
and Contact information in this menu.
Figure 3- 3. Configure Switch IP Settings
To manually assign the Swi
ress:
Sel
the Switch from the subnet on which it is installed, you can leave the default
ill access the Switch. The Switch will allow management access from stations with the same VID
BOOTP or DHCP protocols to assign the Switch an IP address, subnet mask, and default gateway
from BOOTP or DHCP. This selects how the
Switch will be assigned an IP address on the next reboot.
located in the Basic Setup folder.
To configure the Switch’s IP address:
Open the Basic Setup folder and click the Basic
Switch Setup menu button. The web manager
will display the Current Switch IP Settings at
the top of the menu interface. Use the IP settings
fields under New Switch IP Settings to change
the IP settings on
instructions below.
It is also possible to provide Name,
ess
fault gateway of
0.0.0.0.
NOTE: the Switch’s
factory default IP addr
is 10.90.90.90 with a
subnet mask of 255.0.0.0
and a de
tch’s IP address, subnet mask, and default gateway add
ect Manual from the Get IP From drop-down menu.
Enter the appropriate IP address and subnet mask.
If you want to access the Switch from a different subnet from the one it is installed on, enter the IP address of the
gateway. If you will manage
address (0.0.0.0) in this field.
If no VLANs have been previously configured on the Switch, you can use the default VLAN ID (VID) 1. The
default VLAN contains all of the Switch ports as members. If VLANs have been previously configured on the
Switch, you will need to enter the VLAN ID of the VLAN that contains the port connected to the management
station that w
listed here.
To use the
address:
Use the Get IP From:
36