D-Link DES-3326SR Manual - page 192
D-Link DES-3326SR Layer 3 Switch
OSPF Host Route Settings
OSPF host routes work in a way analogous to RIP, only this is used to share OSPF information with other OSPF
routers. This is used to work around problems that might prevent OSPF information sharing between routers.
To configure OSPF host routes, click the OSPF Host Route Settings link. To add a new OSPF Route, click the
New button. Configure the setting in the menu that appears.
Figure 24- 14. OSPF Host Route Settings
To add a OSPF Host Route on the switch, click the New button:
Figure 24- 15. OSPF Host Route Settings
− Add
Specify the host route settings and click the Apply button to add or change the settings. The new settings will
appear listed in the OSPF Host Route Settings list.
The following fields for OSPF host route can be set or are displayed::
Parameter Description
Host Address
The IP address of the OSPF host.
Metric
A value between 1 and 65,535 that will be advertised for the route.
Area ID
A 32-bit number in the form of an IP address (xxx.xxx.xxx.xxx) that uniquely
identifies the OSPF area in the OSPF domain.
182