D-Link DES-3326SR Manual - Chapter 22
D-Link DES-3326SR Layer 3 Switch
Chapter 22
Static Route, Static ARP and RIP Configuration
Configure Static Routes
Configure Static ARP
Routing Information Protocol (RIP) Configuration
This chapter describes how to configure static routes, create permanent entries for the ARP table, and set up RIP.
For more information on static routes (IP routing) ARP and RIP, please read Appendix C.
Configure Static Routes
Entries into the Switch’s forwarding table can be made using both MAC addresses and IP addresses. Static IP
forwarding is accomplished by the entry of an IP address into the switch’s Static IP Routing table. Static routes
that have been previously configured appear in the Static/Default Route Settings table.
To enter an IP address into the Switch’s IP Forwarding Table, open the Forwarding Folder and then the IP
Forwarding folder, and the click the Static/Default Routes link:
Figure 22- 1. Static/Default Routes
To delete an existing static/default route, select the route and the click the Delete button.
To add a new static/default route, click the New button:
Figure 22- 2. Static/Default Routes – Add
152