D-Link DES-3326SR Manual - page 59
D-Link DES-3326SR Layer 3 Switch
Traffic Segmentation
The traffic segmentation table is used to limit traffic flow from a single port to other ports on the switch. It
cannot be used to segment traffic between switch units in a stack. For this it would be appropriate to use VLANs
or a filtering method. This provides an additional tool to direct traffic flow without relying on the Master CPU.
Edit the Traffic Segmentation for each port with the Edit menu (below).
Click the selection button on the far left that corresponds to the port
you want to configure and click the Edit button. This will open the
following dialog box:
Figure 5- 7. Traffic Segmentation – Edit
In the Edit menu, select the Forward Ports for the specified port. A
Forward Port is a port that is allowed to receive transmissions for the
specified port.
Traffic segmentation settings are applied to each Switch individually.
There is no traffic segmentation between Switches in a stacked group.
Although the same effect can be achieved using other mechanisms
such as filtering or VLANs.
Figure 5- 8. Traffic Segmentation Table
To configure Traffic Segmentation for a port, select the ports from the Port List that are allowed to receive
forwarded frames from the port that is being configured. Click the Apply button to add the ports to the forward
list.
49