D-Link DSN-5210-10 - xStack Storage Area Network Array Hard Drive Cli User's Manual - page 32
22
Chapter 3 Using the CLI
The caret character provides a shortcut for executing commands available at the top (root)
context from any subcontext. Issuing this command leaves you in the current context. For
example, createVolume is a command that is available at the root level. If you are in a
subcontext and want to issue the CreateVolume command, type a caret followed by the
command, as shown in the following example.
^createVolume Engineering 30GB mirror
3.2 Specifying Operating Modes
The CLI provides the following operating modes:
Output mode – see section 3.2.1.
Indication mode – see section 3.2.2.
Stream mode – see section 3.2.3.
Completion code – see section 3.2.4.
Echo Command mode – see section 3.2.5.
Exit Script on Error mode – see section 3.2.6.
Each operating mode operates independently of the other modes, and can be configured
independently using the Mode command. The following sections describe these operating
modes.
To see the status of these operating modes, type Mode and press Enter. The
figure below shows an example of the status information returned.
Figure 3-1. Example of Viewing Operating Modes