D&R Airlab User Manual - 9 Timer And System-Setup
Timer and System-setup
Airlab from D&R Phone +31 294 418014, email:
info@d-r.nl
Page
32
9 TIMER AND SYSTEM-SETUP
This part of the Airlab is actually
the most interesting part.
In this section decisions are made
and stored on memory cards for
later retrieval.
There are two important systems
active here.
1.
Programming of your
Airlab configuration.
2. Internal
TIMER.
The following functions can be
programmed per module:
• Module set as DJ mic
input
• Module set as Announcer
mic input
• Module set as Studio mic
input
• Start/Stop
plus
Pulse/Continue per
module
• CUE start active
• Fader start or/and "ON"
start per module
• External remote (in)active
per module
• Timer start pulse per module and per item
• On-Air control signal on/off per module and per item
• Auto Communication Announcer on/off
• Auto CUE reset on/off
• Auto CUE on/off
The exact programming will be dealt with in a separate chapter.
9.1 CUE RESET
Pressing this large switch resets all activated CUEs in all channels.