D&R Airlab User Manual - Lineb Timerstrt?
How to program the Airlab
Airlab from D&R Phone +31 294 418014, email:
info@d-r.nl
Page
49
LINE B ENABLES START TIMER
To enter the next programming possibility you simply hit the
DOWN button again and you'll see a new item. See on the
right what the LCD shows:
This option allows you to select one or more modules, which
need to be able to activate the internal TIMER when in Line B
input position.
HOW TO PROGRAM
The SELECT switches in the modules have a dual function. They select the module you are programming
and at the same time you can toggle between the active and not active setting. This is a very quick way of
programming this function. If you have already programmed several modules, the moment you enter this
menu again the LED’s located near the SELECT switch will light up, on those modules that are
programmed to start the TIMER.
MIC ENABLES TIMER START
To enter the next programming possibility you simply hit the
DOWN button again and you will see a new item. See on the
right what the LCD shows:
This option allows you to select one or more modules, which
need to be able to activate the internal TIMER when in Mic
input position. Not available for Telco Module.
HOW TO PROGRAM
The SELECT switches in the modules have a dual function. They select the module you are programming
and at the same time you can toggle between the active and not active setting. This is a very quick way of
programming this function. If you have already programmed several modules, the moment you enter this
menu again the LED’s located near the SELECT switch will light up, on those modules that are starting the
TIMER
LINE A ENABLES START
To enter the next programming possibility you simply hit the
DOWN button again and you will see a new item. See on the
right what the LCD shows:
This option allows you to select one or more modules, which
need to be able to give a start pulse, when set in Line A input
mode. Always on for Telco module.
HOW TO PROGRAM
The SELECT switches in the modules have a dual function. They select the module you are programming
and at the same time you can toggle between the active and not active setting. This is a very quick way of
programming this function. If you have already programmed several modules, the moment you enter this
menu again the LED’s located near the SELECT switch will light up on the modules that are enabled to
trigger the fader start.