How to program the Airlab
Airlab from D&R Phone +31 294 418014, email:
info@d-r.nl
Page
61
STORE
In the Store menu you can store a setup to the internal
memory. By pressing the ENTER switch the actual data will
be stored to memory. Subsequently by pushing the ESC
switch, the Store menu will be left.
RECALL Memory Card
In the Recall memory card menu you can recall a stored
setup from a Memory card. By pressing the ENTER switch
the actual data will be recalled from an inserted memory card.
Subsequently by pushing the ESC switch the Recall Memory
card menu will be left.
STORE Memory Card
In the Store Memory Card menu you can store a set-up to an
inserted memory card. By pressing the ENTER switch the
actual data will be stored to an inserted Memory Card.
Subsequently by pushing the ESC switch the Store Memory
card menu will be left.
All the above explained programming and storing of data can be performed on a Windows PC. You need to
connect the RS232 SubD9 connector of the Airlab to the RS232 connector of your PC and load the Airlab
software. All module and master programming can be dealt with on one PC screen. In this way you will
have a total view of your settings on one screen. This can be edited and when you sorted out all your
settings it can be downloaded to the Airlab’s memory and subsequently stored on a memory card.