D&R Airlab User Manual - Linea On Air-1?
How to program the Airlab
Airlab from D&R Phone +31 294 418014, email:
info@d-r.nl
Page
54
ON AIR-1 ACTIVE FOR LINE A
To enter the next programming possibility you simply hit the
DOWN button again and you will see a new item. See on
the right what the LCD shows:
This option allows you to set one or more modules to toggle
the ON-AIR-1 relay, when in Line A input mode.
HOW TO PROGRAM
The SELECT switches in the modules have a dual function. They select the module you are programming
and at the same time you can toggle between the active and not active setting. This is a very quick way of
programming this function. If you have already programmed several modules, the moment you enter this
menu again the LED’s located near the SELECT switch will light up on the modules that are toggling the
ON-AIR 1 relay when line A is selected.
ON AIR-1 ACTIVE FOR LINE B
To enter the next programming possibility you simply hit the
DOWN button again and you will see a new item. See on
the right what the LCD shows:
This option allows you to set one or more modules to toggle
the ON-AIR-1 relay, when in Line B input mode.
HOW TO PROGRAM
The SELECT switches in the modules have a dual function. They select the module you are programming
and at the same time you can toggle between the active and not active setting. This is a very quick way of
programming this function. If you have already programmed several modules, the moment you enter this
menu again the LED’s located near the SELECT switch will light up on the modules that are toggling the
ON-AIR 1 relay when line B is selected.
ON AIR-1 ACTIVE FOR MIC
To enter the next programming possibility you simply hit the
DOWN button again and you will see a new item. See on
the right what the LCD shows:
This option allows you to set one or more modules to toggle
the ON-AIR-1 relay, when in Mic input mode. Not available
for Telco Module.
HOW TO PROGRAM
The SELECT switches in the modules have a dual function, they select the module you are programming
and at the same time you can toggle between the active and not active setting. This is a very quick way of
programming this function. If you had already programmed several modules, the moment you enter this
menu again the LED’s located near the SELECT switch will go on, on those modules that are toggling the
ON-AIR 1 relay when MIC is selected.