How to program the Airlab
Airlab from D&R Phone +31 294 418014, email:
info@d-r.nl
Page
62
14.4
TIMER
As earlier mentioned the Airlab has a built in Timer, which is practical and easy to use.The Timer menu
is the basic menu that the Airlab always shows.
To activate the timer it is necessary to first program the modules and make up your mind which
modules and in which mode they should trigger the Timer.
Any module that has been programmed to start the timer shall trigger the timer and the clock is
running, reading from left to right: hours, minutes and seconds.
The moment you pull down a fader or switch an ON switch off the timer stops showing the exact time
the module has been active.
As soon as you open the module again, the timer will be reset it and starts all over again.
The Timer can also be started and stopped by the ENTER switch.
It goes like this:
1. With ENTER the timer will be reset and starts or continues to run.
2. With ESC the timer will be reset and when it runs it continues to do so.