Triple Line Input Stereo Module
Airlab from D&R Phone +31 294 418014, email:
info@d-r.nl
Page
8
4 TRIPLE LINE INPUT STEREO MODULE
MONO
Every channel has a mono switch with LED to send a mono input signal to both outputs of
the module.
(PHANTOM POWER, not on front panel.
48 volt switchable by a jumper setting (see also chapter 12))
MIC-TRIM
The trim control adds an extra 13dB of mic gain to the mic pre-amp. An optimal gain range
can be accomplished in this way.
GAIN
The gain control adjusts the incoming signal level on the MIC and LINE input.
LINE A
The triple module default is in 'LINE A' mode. Operating the 'LINE B' switch or the MIC
switch changes the mode.
LINE B
When line B is selected (with optional RIAA correction amp), the green LED is illuminated.
MIC
MIC input selector switch between MIC-input or Line-A/B input. When the LED is illuminated
the MIC-input is activated.
HIGH
Adjusts high frequencies with +/- 12 dB at 10 kHz shelve.
MID
Adjusts mid frequencies with +/- 12 dB at 1 kHz bell.
LOW
Adjusts the low frequencies with +/- 12 dB at 60 Hz bell.
SUB
The sub switch assigns the signal in stereo to the sub output.
PROG(RAM)
The program switch assigns the signal in stereo to the program output.
STEREO AUX
Transmits a stereo signal to the AUX master post fader. A jumper on the board determines
whether this is pre or post VCA.
The channel 'ON' switch also affects the aux send (only when set to post fader).