Back Panel Connectors
Airlab from D&R Phone +31 294 418014, email:
info@d-r.nl
Page
36
STUDIO
The two Cinch connectors are the unbalanced Studio outputs. The level is +6 dBu at 47 Ohm.
SUB OUTPUTS
These outputs are electronically balanced and wired to male XLR outputs.
Output level is +6 dBu at 47 Ohm. (Transformers are optional)
RS232
This computer type connector is the interface between the Airlab and a PC. Through this connector and the
delivered software it is possible to program the Airlab on your PC.
Chapter 14 will give you detailed information about this programming.
TO METER
This SubD9 connector provides power and signal to all 4 meters.
MORE OUTPUTS
In this section of the master back panel you find the following output connectors.
Tape-1 out stereo, Tape-2 out stereo, AUX. out stereo, CUE out stereo, CRM out stereo and PROGRAM
left/right.
PROGRAM OUTPUTS
The Airlab contains two electronically balanced outputs that can be transformer balanced as an option.
Both outputs shall have their own line output amps with high quality output transformers as an option. The
output level is +6 dB at 600 Ohm when the meter reads 0 dB.
Connectors are XLR male:
Pin 1 = ground
Pin
2
=
in
phase
Pin 3 = out of phase
If the Airlab is required to drive unbalanced equipment, Pins 1 and 3 must be shorted.
PHONES OUTPUT
The engineer's stereo headphone output shall also be used as DJ output.
NOTE: DO NOT use headphones with an impedance lower than 200 Ohm. 600 Ohm is
preferable. The jack is positioned on your right hand side under the armrest.
Connector type is stereo jack plug:
Tip
=
left
Ring
=
right
Sleeve
=
ground