JabloCom EYE-02 User Manual - page 14
JR_EYE-02.ENG.MAN.Manual.12.D
- 12 -
There are many types of event records. The most important are ALARM reports, which are re-
ported to the contacts from the contact list immediately. Other types of records are the ALERT
records (similar to ALARM, but ALERTs are not reported to the contacts) or some technical
reports (Example: information about the AC power failure).
4.4 Video Record Setting (Available through JabloTool only)
The EYE-02 camera allows detail setting of all important parameters for collecting video records under
many conditions.
Parameter
Settings
Description
Snapshoot interval
from 20 frames per sec, to 1 frame
every 5sec
The frequency of snapshots. Higher fre-
quency increases the video record file size.
After ALARM keep on
recording video for
(0 sec, 5sec, 10sec ,... 2 min, 5 min,
10 min)
Default value is 20 seconds
Camera keeps video recording for some
time period after ALARM.
Save pictures only when a
motion is detected
Next snapshoot (frame) will be saved to video record file only if there has been
detected the change compare to previous snapshoot. If the pictures are almost the
same it will not be stored. This setting SIGNIFICANTLY reduce the video file size
Image size
160x120, 320x240, 640x480 pixels
Default value is 320x240 pixels
Image resolution in pixels. Higher resolution
increases the quality of recorded pictures
but it also increases the size of video files
and lengthens the time for transfer it via
GSM network.
Image quality
5 levels of JPEG compression
Level of JPEG compression. Higher com-
pression reduces the file size and slightly
decreases the detail resolution in picture.
Filter fluorescent lamps
(OFF, 50Hz, 60Hz), default OFF
If the scene is illuminated by the standard
fluorescent lamps, this will filter undesirable
lamp blinks. Set the standard AC power
frequency in your country.
Brightness compensation
+/- 2EV, with step 0.5EV, default 0
A camera calculates the best brightness of
pictures automatically. This setting allows
changing the pre-set level of brightness.
Expected speed of the
objects (Shutter speed)
(fast, normal, slow), default normal
Default setting is NORMAL. Set of FAST in
case there may be some fast moving objects
in front of camera (cars, running persons,
etc.), SLOW is suitable mainly for door con-
trol and dark rooms.
Disable build-in infrared
lamp
An internal IR lamp is automatically switched on when the lightness of scene is too
low for normal camera function. This option disables the automatic function and it
is mostly used if the illumination is done by external lamp.
Insert date and time into
picture
The small timestamp will be inserted into the left top corner of picture. This helps to
determinate exactly the time of snapshot.
Capture video during
PIR or MIP activity
in SLEEP mode
The video recording continues also in SLEEP mode if there is some activity detected
in front of camera. This is well usable for shops, petrol stations and other place
where permanent watching is required.
Send video as separate
JPEG pictures
5 JPEG pictures will be sent by e-mail instead of AVI video files.
Please consider that even though the size of MMS and e-mail is limited to 300kB, sending such
MMS or e-mail may take up to several minutes according to your local network conditions.
To reduce the file size and fasten sending you can choose a lower image resolution, snapshot
interval or recording duration.