JabloCom EYE-02 User Manual - page 18
JR_EYE-02.ENG.MAN.Manual.19.C-2A
- 18 -
EN
EN
U
se
r‘s
G
ui
de
7. T
JABLOCOM will periodically release new versions of the EYE-02 camera software as well as the JabloTool software. Visit
www.jablocom.com to find the latest version of the EYE-02 camera firmware, supporting software and detailed guide
to troubleshooting.
Problem / Error message
Solution
RED light on the front
camera panel
•
Your SIM card is out-of-service or blocked by a PIN code – remove the SIM card the camera, put it into
your GSM phone and try to make a call and send an SMS. If PIN protected, please remove the PIN or
set it to default network value.
•
Your SIM card isn’t placed in the SIM holder correctly, or the camera doesn’t support your SIM card
type. Check if the SIM card is placed in the holder correctly or contact your GSM service provider.
•
Camera location is not covered by GSM network signal - check the quality of GSM network signal
directly at the place of the camera installation: place your mobile phone close to the camera, wait
a few seconds and read the signal strength from your phone display. If the signal is too low you might
try to replace original camera GSM antenna by another approved type of GSM antenna with a higher
gain.
The EYE-02 camera doesn’t
react to
remote control
•
Flat battery in your remote control – press a button and check if the light on your control goes on. If
not, replace the remote control internal battery.
•
The remote control has been accidently deleted from the EYE-02 camera configuration. Use PC with
JabloTool software, open the ENROLL mode and press any button of your remote control to enroll it in
to the EYE-02 camera.
If you discover abnormal EYE-02 camera behavior, please try to update EYE-02 camera firmware to the latest version. To do this, use
JabloTool, Configuration, Control panel, Firmware upgrade.
8. T S
Camera dimension
155x75x55 mm, 300 g
Package dimensions
300x215x75 mm, 950 g
Extended memory capacity
SD micro card slot, maximum capacity 32 GB, standard Package includes 2 (1) GB SD memory
card
1
Image resolution
VGA (640x480), QVGA (320x240), QQVGA (160x120)
Picture format
JPEG, EXIF 2.2
Video format
MJPEG
Lens
focal length 2.9 mm, view angle 95°
Infra reflector
6x Infra LED, 6x 100mW, wavelength 850nm, emitting angle 80°
PIR motion detector
detection range 10m / 140°
MMS support
MMS version 1.2 over WAP 2.0
Events history
min 100 records in an internal memory + extension to SD card
Operating temperature
-20 °C to +55 °C; 25 to 75 % humidity
AC power adaptor
100 - 240 V AC, 50 to 60 Hz, 6 V / 1.67 (2) A DC
1
Input power (range)
5.0 - 6.7 V / 1 A DC
Back-up battery
Li-Ion battery, 1300 mAh
2
Network connectivity
GSM quad band 850/900/1800/1900 MHz for EYE-02
GSM dual band 900/1800 MHz and UMTS dual band 900/2100 MHz for EYE-02 3G
GSM antenna
External GSM antenna , SMA connector
Data connectivity
EDGE class 10: max. 180 kbps DL / 120 kbps UL, GPRS class 10: max. 85.6 kbps, CS1-4
UMTS PS rate – 384 kbps DL / 384 kbps UL, UMTS CS rate –
64 kbps DL / 64 kbps UL for EYE-02 3G only
Audio parameters
AGC and Noise reduction system, HR, FR, EFR and AMR audio codec
Audio monitoring
Built-in high sensitivity omni-directional microphone with DSP processing
PC connectivity
USB port 2.0
Internal alarm detectors
Motion-in-Picture detector, PIR motion detector, Glass break detector, Tilt and vibration
detector
Short range radio
868 MHz, Operated according to ERC REC 70-03
Remote control type
RC-86
Alkaline battery type L1016 (6.0 V), Typical battery lifetime approx. 3 years
Complies with ETSI EN 300220,EN 55022, EN 50134-2,EN50130-4, EN60950-1
1
May vary depending of production series.
2
Possible to use Nokia NLC-2 battery.