JabloCom EYE-02 User Manual - page 5
JR_EYE-02.ENG.MAN.Manual.19.C-2A
- 5 -
U
se
r‘s
G
ui
de
EN
Plug the power cable to the camera.
Plug the power adaptor to a wall socket. The camera will automatically turn on. Wait 30 seconds
and check the EYE-02 camera LED lights on the front panel.
• Enroll your mobile phone and remote control to the camera
Call the camera number from
your mobile phone.
On the remote control, press the button
.
3. C F
3.1 W M
The EYE-02 camera has three main working modes:
SLEEP
,
WATCH
and
CONFIG
.
Mode
Description
Button on
the Remote Control
SLEEP
SLEEP mode is a stand-by mode of the camera. The camera doesn’t detect
any movement in the targeted area and the major detectors are disabled.
The only active detectors are those that protect camera itself against an
unwanted manipulation by an intruder.
WATCH
In WATCH mode camera guards fully the targeted area, all detectors are
active.
CONFIG
CONFIG mode allows user to change camera settings and switch the camera
to other special modes (ENROLL, TEST, USB).
and
together
The chosen camera mode is terminated by switching to a different camera mode.
3.2 R C
The package contains a wireless remote control (RC-86 type), which
can be used to switch between camera modes.
Changing a mode by using the remote control is signaled both by
the LED lights on the camera front panel, and by an acoustic signal.
Meaning of the LEDs and acoustic signals is as follows:
Remote control