Karassn KS-200B Series User Manual - page 15
2. Programming setup of alarm host
After it is power on, the display screen of the alarm host shows
"12:00 00". The second light is flashing and the last two bits display
second. Press the "Function" key to enter into setup mode, in the
mean while, the second light is continuously on and the last two bits
are flashing, which is the function menu. In this case, the alarm host
won't receive any alarm signal of a detector. In function state, press
"Function" key can switch among functions. And press "reset" key
can exit the setup mode. In setup mode, if there is no operation
within 30 seconds, the system will automatically exit the setup
mode and return to display clock.
(1) Clock setup
In clock display mode, press "Function" key, the following content
will be displayed:
In this case, press "
˘" or "˚" to adjust the time. Press "reset" key
to complete and exit the setup, or press "Function" key to set auto
startup time of the first group"
(2) Set auto startup time of the first group
After entering into "setup auto startup time of the first group",
press "
˘ " or "˚ " key to adjust the auto startup time of the first
group. After the setup is finished, press "reset" key to exit the setup
or press "Function" key to set "auto shutdown time to the first
group". The above figure shows that the auto startup time of the first
Function 1
Key to set clock setup
Hour
press
˘key to set
Minute
press
˚key to set
Function 2
startup time of the first group
Hour
press
˘key to set
Minute
press
˚key to set