Karassn KS-200B Series User Manual - page 19
KS-200BMI alarm host and KS-200BM alarm host are the same
setup grogram. The telephone alarm function setup is used to alarm
host connect the external telephone machine. More details please
refer to the following:
Note
The telephone used to program should be DTMF (Double Tone
Multi-Frequency) phone. Please turn the P/T switch to "T" position.
The host should be in the state of defense deactivation during
setup operation to against triggering alarm signal.
Every step has a indicative sound
A short sound "beep"---shows the operation effective.
A long sound "beep"---shows the operation ineffective.
When the system enters into the state of alarm setup the telephone
is powered by the alarm host, yet the current electricity is limited. If
you use the hands-free function to set alarm you may fail or hear no
sound. Therefore you'd better use the handset to set alarm.
Program operation
Well connect the alarm host according to the charter of " Interface
performance and system connection". Hang up the handset.
Press:
# # #------a short sound "beep" shows the system has entered into
the state of setup. Press
A A A A A A #------enter into the password and confirm.
A A A A A A # stands for the password. The original password is 0 0
0 0 0 0. There shall be a short sound "beep", if the password is right.
Then going on next operation. Or it will exit the setup state, it the
password is wrong. The password is modifiable. To modify it,
please refer to the " password modification" charter.
Note
After press # # #, the line will be cut off. The telephone is powered
by the alarm host. There shall be not dialing tone and other voice
signal. Or it shows the line still connect, and shall press again or