Kawasaki KX65 - Owner's Manual - page 48
47
j
•
If the play is incorrect, pull the rubber boot off the
upper end of the throttle cable, loosen the locknut
on the upper end of the throttle cable and turn the
adjuster to obtain the specified play. Then, tighten
the locknut.
•
Reinstall the rubber boot.
A. Adjuster
B. Locknut
C. Throttle Cable
•
If the free play cannot be set with the adjuster on
the upper end of the throttle cable, pull the rubber
boot off top of the carburetor and make the neces-
sary free play adjustment with the adjuster on the
lower end of the cable. Then, tighten the locknut
and reinstall the rubber boot.
A. Locknut
B. Adjuster
•
With the engine idling, turn the handlebar both
ways and check if handlebar movement changes
the idling speed. If so, the throttle cable may be
improperly adjusted or incorrectly routed, or dam-
aged. Be sure to correct any of these conditions
before riding.
WARNING
Operation with an improperly adjusted, in-
correctly routed, or damaged cables could
result in an unsafe riding condition. Be sure
the control cables are adjusted and routed
correctly, and are free from damage.