Kawasaki KX65 - Owner's Manual - page 58
57
j
A. Apply grease.
•
Turn the clutch release lever toward the rear.
•
Place a new right engine cover gasket in position
with a thin layer of grease.
•
Apply a high-temperature grease to the kick shaft
oil seal lips and kick shaft spline.
•
Install the right engine cover to the crankcase,
making sure that the two dowel pins are installed
between the making surfaces.
•
Route the breather hose through the clamp and
position it as shown with the right engine cover
mounting bolt.
A. Dowel Pins
B. Breather Hose
C. Clamp
•
Tighten the right engine cover mounting bolts.
Right Engine Cover Mounting Bolt Tightening
Torque
9.4 N·m (0.96 kgf·m, 83 in·lb)
•
Connect the lower end of the coolant hose, and
tighten the clamp screw securely.
•
Install the impeller and washer to the right engine
cover, and tighten the impeller bolt.
Impeller Bolt Tightening Torque
8.3 N·m (0.85 kgf·m, 74 in·lb)