Kawasaki KX65 - Owner's Manual - page 59
58
j
•
Place a new water pump cover gasket, and install
the water pump cover, and tighten the water pump
cover bolt.
Water Pump Cover Bolt Tightening Torque
9.4 N·m (0.96 kgf·m, 83 in·lb)
•
Connect the lower end of the water pump hose,
and tighten the clamp screw securely.
•
Check the brake pedal O-ring for damage, and if
necessary, replace them with a new one.
•
Apply a high-temperature grease to the shaft por-
tion of the rear brake pedal, install the rear brake
pedal and attach the return spring onto the frame.
Brake Pedal Mounting Bolt Tightening Torque
25 N·m (2.5 kgf·m, 18 ft·lb)
•
Install a new cotter pin, pivot pin and washer to
the rear brake pedal, and spread the ends of the
cotter pin.
•
Install the kick pedal, and connect the clutch cable.
Kick Pedal Bolt Tightening Torque
9.4 N·m (0.96 kgf·m, 83 in·lb)
•
Test the braking power and check that there is no
brake drag.
WARNING
Air in the brake lines diminish braking perfor-
mance and can cause an accident resulting
in injury or death. If the brake lever or pedal
feels mushy when it is applied, there might
be air in the brake lines or the brake may be
defective. Have the brake checked immedi-
ately by an authorized Kawasaki dealer.
•
Adjust the clutch cable.
•
Check the transmission oil level and coolant level.
•
Install the parts removed.