Kawasaki KX65 - Owner's Manual - page 57
56
j
Friction and Steel Plate Installation
•
Install all parts in the reverse order of removal.
•
Install the friction plates and steel plates, alternat-
ing between the two; be sure to start and finish
with a friction plate.
A. Friction and Steel Plates
NOTICE
If dry steel plates and friction plates are
installed, apply transmission oil to the sur-
faces of each plate to avoid clutch plate
seizure.
•
Install the clutch hub, springs and clutch spring
holder.
•
Tighten the clutch hub bolt and clutch spring bolts.
Clutch Hub Nut Tightening Torque
64 N·m (6.5 kgf·m, 47 ft·lb)
Clutch Spring Bolt Tightening Torque
9.3 N·m (0.95 kgf·m, 82 in·lb)
•
Apply molybdenum disulfide grease to the clutch
spring plate pusher.
•
Install the clutch pusher and clutch spring plate
pusher.
•
Install the magneto cover and gasket.
•
Apply molybdenum disulfide grease to the water
pump shaft to prevent water pump seal damage.
NOTICE
If the right engine cover is installed without
greasing the water pump shaft, the pump
seal could be damaged.