KEB COMBIVERT F6 Instructions For Use Manual - page 40
3.3.3 Through-mount version air cooler IP54
90,5
8
172
468
7,5
285
520
101
7,5
10x101=(505)
270270
90
80
M5
L2
L3
+
-
R
U
V
M6
90
270
(135)
244
5 x 101 = (505)
101
11,5
480
DEV
VCC
NET
OPT
ST
ST
FS
ST
Housing size
6
Weight
20.6 kg
Figure 6:
Dimensions through-mount version air cooler IP54
IP54 zone: Heat sink underneath the mounting plate. For proper installation,
the enclosed seal (60F6T45-0002) must be installed between heat sink and
housing (e.g. cabinet wall). The tightness must be checked after the installa-
tion. If properly installed, the separation to the housing corresponds to degree
of protection IP54. However, the fans must be protected against unfavorable
environmentalinfluences.Theseincludecombustible,oilyordangerousfumes
or gases, corrosive chemicals, coarse foreign bodies and excessive dust. This
applies especially to the access of the heatsink from the top (air outlet). Icing
is inadmissible.
IP20 zone: device above the mounting plate, power connections excluded =>
. This part is intended for the installation in a suitable
housing for the required degree of protection (e.g. control cabinet).
UL:UnitheatsinkisclassifiedasNEMAtype1.
40
DIMeNSIONS AND WeIGHTS