NAMCO PAC-MAN SWIRL Operation Manual - page 20
3. Setup
20
- Must be performed by a technician -
Secure the four control panel assemblies using the two Phillips pan head screws (w/washers)
(M4 x 16) and the two Phillips pan head screws (w/washers) (M4 x 8) so that the color of the
station and control panel assembly match, and then connect the harness connector (8-pin).
Phillips pan head screw
(with/washers) (M4 x 8)
Phillips pan head screw
(w/washers) (M4 x 16)
Control panel assembly
(The color must match those
of the 7-SEG LED ACRYL.)
7-SEG LED
ACRYL
Wing bolt (M4 x 10)
AC CORD SHUTTER
Harness connector (8-pin)
Open the MAINT DOOR A, pass the power cord through the slit on the bottom of the machine,
and plug the power cord into the AC inlet. (Be sure to use the power cord with a plug that fits
into the inlet.).
Loosen the wing bolt (M4 x 10), slide the AC CORD SHUTTER to narrow the slit, and tighten
the wing bolt.
Put the machine in Ball Supply test mode and replenish with 26 balls (four spare balls will remain).
(See “5-6-2 BALL SUPPLY” on page 43.)
Replenish the coupon tickets.
Exit test mode and close all open doors.