NAMCO PAC-MAN SWIRL Operation Manual - page 3
1. Safety
Test Mode
Troubleshooting
3
Precaution
Critical Safety Precautions
z
z
Should an abnormality occur, turn off the power switch immediately to stop operations. Then, be
sure to disconnect the power cord plug from the outlet. Operating the machine while the abnormality
persists may result in fire or accident.
z
z
Dust accumulating on the power cord plug may cause fire. Inspect the plug regularly and remove
any dust.
z
z
Fully insert the power cord plug into the outlet. Poor contact may generate heat and cause fire or burns.
z
z
Damage to the power cord may result in fire, electric shock or electrical leakage. Be sure to observe
the following.
• Keep the power cord away from heaters.
• Do not twist the power cord.
• Do not forcibly bend the power cord.
• Do not alter the power cord.
• Do not bundle the power cord.
• Do not pull the power cord. (Always unplug by holding the plug and not the power cord.)
• Do not place objects on the power cord.
• Do not allow the power cord to be caught between the machine and other devices or the wall.
• Do not do anything else that might damage the power cord.
z
z
Do not expose the power cord and power cord plug to water. It may result in electric shock or
electrical leakage.
z
z
Do not touch the power cord plug with wet hands. It may result in electric shock.
z
z
The power capacity of the machine is maximum current consumption 1.3 A in case of 230 V AC
specifications, or maximum current consumption 3 A in case of 100 V AC specifications. To prevent
fire and electric shock, use indoor wiring that conforms to these power supply specifications.
z
z
Use a power supply voltage range of 100 to 240 V AC. Using a voltage outside this range may result
in fire or electric shock. However, to ensure that the machine operates in the optimum condition,
keep the voltage at 100 to 240 V AC as much as possible.
z
z
Be sure to use the power cord that matches the AC voltage for the machine. Use of an inappropriate
power cord may result in electric shock or fire.
z
z
Use the consumables and service parts (including screws) that are specified by our company. Use
of non-specified consumables and parts may result in unforeseen hazards. To order parts, contact
your distributor.
z
z
Do not modify the machine without permission. Do not perform any operations that are not described
in this Operation Manual. Modifying the machine may create unforeseen hazards.
z
z
If you decide to transfer the ownership of this machine, be sure to provide this Operation Manual
with the machine.