NAMCO PAC-MAN SWIRL Operation Manual - page 22
22
4-2 Daily inspection
4-2-1 Pre-operation Inspection
Check the items below before starting machine operations. If there is an abnormality, resolve it by referring to “7-2
4-2-2 Points for Safety Inspection (Before Power On)
z
z
Before operating the machine, check the following items. This is required to prevent accidents or
injury.
(1) Are all warning labels in place? (See “Machine Warning Labels” on page 4.)
(2) Are all warning labels legible? (See “Machine Warning Labels” on page 4.)
(3) Are all level adjusters adjusted properly? (See “3-5 Setup and Assembly” on page 18.)
(4) Is the specified play zone provided? (See “3-3 Play Zone for Installation” on page 13.)
(5) Is the power cord laid out safely so that it will not cause players or other customers to trip over it?
(6) Is the power cord securely connected to the outlet and the power supply input of the machine? (See “3-5
Setup and Assembly” on page 18.)
(7) Is the power cord plug free from dust?
Inspect the following items after turning on the power switch. If you discover an abnormality, turn off the power
switch immediately to stop operations. Then, disconnect the power cord plug from the outlet and contact your
distributor.
(8) Is any part of the power cord or plug abnormally hot?
(9) Does touching the machine give a tingling electric shock?
(10) Is there a burning smell, abnormal noise or vibration?
(11) Is there any other abnormality or malfunction?