NAMCO PAC-MAN SWIRL Operation Manual - page 67
67
Test Mode
7. Troubleshooting
Troubleshooting
Disassembling/Replacement Procedure
- Must be performed by a technician -
7-3-9 TABLE DRIVE MOTOR
Core assembly (table)
Loosen the two pan head screws
(w/washers) (M4 x 6).
The screws protruding through
these holes are not firmly tightened.
GUARD F
Pan head screws
(w/washers)
(M4 x 6)
Disconnect a cord
from the faston terminal.
ROLLER MOTOR
BRACKET D
TABLE DRIVE MOTOR
(w/gearhead)
Set screw
(double points)
(M4 x 6)
Coupling hub
and slider
Pan head screws
(w/washers)
(M4 x 8)
Station 2 (blue)
Remove the MAINT DOOR C on Station 2 (blue) using the service key.
Loosen the upper two pan head screws with washers (M4 x 6) to remove the GUARD F.
Unscrew the four pan head screws with washers (M4 x 6) and disconnect the faston terminal
to remove the ROLLER MOTOR BRACKET D, and disconnect the harness connector from the
TABLE DRIVE MOTOR.
Unscrew the two set screws (double points) (M4 x 6) to remove the coupling hub.
Unscrew the four pan head screws with washers (M4 x 8) to replace the TABLE DRIVE MOTOR.
Note
For details on securing the coupling hub,
see the figure in “7-3-5” on page 62.
Note
For details on coupling the shafts, see the figure in “7-3-5” on