NAMCO PAC-MAN SWIRL Operation Manual - 4. Operation
Test Mode
Troubleshooting
21
Setup and
Assembly / W
arnings
4. Operation
4-1 Warnings
z
z
Should an abnormality occur, turn off the power switch immediately to stop operations. Then, be
sure to disconnect the power cord plug from the outlet. Operating the machine while the abnormality
persists may result in a fire or accident.
z
z
Dust accumulating on the power cord plug may result in a fire. Inspect the plug regularly and remove
any dust.
z
z
Fully insert the power cord plug into the outlet. Poor contact may generate heat and result in a fire
or burns.
z
z
Before operating the machine, be sure to check that installation has been performed according to
the instructions and specified procedures (See “3-2 Installation Warnings” on page 12.) in this
Operation Manual. Failure to install the machine correctly may result in a fire, electric shock, injury
or malfunction.
z
z
The warning labels attached to the machine contain important information for ensuring safety. Be
sure to observe the following. (For the warning label locations, see “Machine Warning Labels” on
• In order to ensure that the warning labels attached to the machine are always clearly visible, install
the machine in an appropriate location with ample illumination and keep the labels clean at all
times. Make sure that the labels are not hidden by other machines or objects.
• Do not remove or alter the warning labels.
• If a warning label becomes excessively dirty or damaged, replace it with a new one. To order
warning labels, contact your distributor.
z
z
To ensure safe use of the machine, be sure to perform the pre-operation inspection (See “4-2 Daily
inspection” on page 22.) and service (See “6-2 Service” on page 47.) in this Operation Manual.
Omitting these inspections or service may result in an accident.